The MPLS WG Archive

Cell Relay Retreat>MPLS WG Archive>month:2006-Oct> msg00041



[Date Prev][Date Next][Thread Prev][Thread Next]  
  [Date Index][Thread Index][Author Index][Subject Index]

[MPLS] LDP GR query

  • From: "Yu Yi" <yuyi@nortel.com>
  • Date: Tue, 17 Oct 2006 11:33:27 +1000
  • Thread-Index: AcbxhklQpekznla3SBmLMlWRvxfqwAABVqSw
  • Thread-Topic: [MPLS] LDP GR query
  • X-MS-Has-Attach: yes

Title: 空白
  I think for this scenario RTA and RTB both consider the peer restart and perform the GR process. So RTA will re-send all mapping and RTB also do so. and then after receiving mapping all the LSP's stale flag are cleared and a perfect GR is finished.
  The traffic won't be lost if the forwarding plane is ok. 

From: little_star@huawei.com [mailto:little_star@huawei.com]
Sent: 2006年10月17日 8:50 AM
To: Ramesh Huliyar; Yi, Yu (SUNP:1G11); mpls@lists.ietf.org
Subject: Re: [MPLS] LDP GR query

Hello,

Then how about another scenario?

Another example that the LDP session will be down when the LSR’s neighbor can’t send out it’s packet, including hello packet or keepalive packet, if the control plane of it’s neighbor is very busy or occurs some error ,then the LDP session will be down. In this case this two LSR will conclude that it’s neighbor restart and the LSR will implement GR flow.

I mean the LDP protocol has some problem.In this case the link is ok,so the BFD can't be used.

 

When they re-establish the session,they will perform GR flow together.

 

 

 

----- Original Message -----
Sent: Monday, October 16, 2006 8:36 PM
Subject: Re: [MPLS] LDP GR query

Hello,

I feel that RTB LDP session will go down with RTA immidietly when the link goes down. After the re-establishment of the LDP session, RTB will be sending FT session TLV with Recovery Time 0. This will cause the RTA to remove the stale FEC-to-label mapping. But until this happens, traffic will be black holed.

To overcome this, other methods of identifying link failures in RTA have to be employed, such as BFD, this will help RTA to use alternate FEC-to-Label mapping, because link failure does not start LDP GR but it will bring down LDP session in case of link level LDP.

Regards
Ramesh Huliyar

----- Original Message ----
From: Yu Yi <yuyi@nortel.com>
To: little_star@huawei.com; mpls@lists.ietf.org
Sent: Monday, 16 October, 2006 2:51:33 PM
Subject: RE: [MPLS] LDP GR query

  For your case it is fine. RTB should be in normal case(normal session down)(no any GR flow) and delete all LSPs which are established on the port.  After session up again RTA will re-send the same label mapping which are sent before session down. But as you know during this period the MPLS traffic are lost. So this is not a complete GR case.
  GR is applicable only if the forwarding plane is fine.
 

From: little_star@huawei.com [mailto:little_star@huawei.com]
Sent: 2006年10月16日 3:07 PM
To: mpls@lists.ietf.org
Subject: [MPLS] LDP GR query

 

Hi

I have query related to LDP Graceful Restart.

RFC 3478 say

When an LSR detects that its LDP session with a neighbor went down,

   and the LSR knows that the neighbor is capable of preserving its MPLS

   forwarding state across the restart (as was indicated by the FT

   Session TLV in the Initialization message received from the

   neighbor), the LSR retains the label-FEC bindings received via that

   session (rather than discarding the bindings), but marks them as

   "stale".

 

  RFC 3478 say that a router will implement GR flow when it detect that its LDP session with a neighbor went down.

 But there are many cases which can cause the LDP session went down ,and it’s neighbor don’t restart actually.

 

Consider this scenario:

 

 

 

 

Suppose that the link between RTB and LAN-SWITCH is broken down, then RTA will detects that its LDP session with RTB went down, then RTA will implement GR flow, even the LDP session between RTA and RTB is re-established after the link between RTB and LAN-SWITCH  is resumed. Because the FT TLV in the initialization message of RTB don’t indicate that RTB whether reboot or not, so RTA is still implement GR flow.

Now RTA is in GR flow , but RTB isn’t in GR flow.

But what will happen if RTA is in GR flow , at the same time RTB isn’t in GR flow? I think it will fall into confusion.

 

Another example that the LDP session will be down is that the LSR’s neighbor can’t send out it’s packet, including hello packet or keepalive packet, if the control plane of it’s neighbor is very busy or occurs some error ,then the LDP session will be down. In this case the LSR will conclude that it’s neighbor restart and the LSR will implement GR flow.

 

_______________________________________________
mpls mailing list
mpls@lists.ietf.org
https://www1.ietf.org/mailman/listinfo/mpls

clip_image002.gif

GIF image

_______________________________________________
mpls mailing list
mpls@lists.ietf.org
https://www1.ietf.org/mailman/listinfo/mpls